Hi all,
I'm looking for a bit of help getting started with my 1820.
I have a ubiquiti edgerouter lite, ac-lite access point and the 1820
I have configured a router on a stick setup with the ubiquiti so the eth 1 port is set up like this:
eth1: 10.1.0.1/16
eth1.10: 10.10.0.1/16
eth1.20: 10.20.0.1/16
so i have the native vlan 1, a vlan 10 for lan and vlan 20 for wireless.
i have dhcp scopes for 10.10.x.x and 10.20.x.x
On the 1820 i have port 24 configured as tagged in 1, 10 and 20 (i believe this is the equivalent of a cisco trunk port?)
i am having problems managing the 1820. i have given it an ip in the vlan 1 subnet (10.1.0.10) and if i give my laptop the ip 10.1.0.50 and connect to it i can manage it. but if i connect and use dhcp to get an ip in the 10.10 or 10.20 range i cant access the switch at all. although i can access the routers ip in vlan 1 (10.1.0.1).
Is there any way i can easily manage the switch from a machine in vlan 10 without having to change its ip etc.? and is it sensible to have all the routing/switching gear in a vlan seperate from the "data" vlans?
Dan