Hello!
I have a switch HP 1920-48G Office Connect.
According to the specification it is level 3.
He's the only smart switch in my network. More than others there.
I want to do routing between VLAN.
According to the guidelines, it is necessary to create 2 or more VLANs (considering that 1 already exists)
Then in these VLAN add the appropriate switch ports
Mark them as unagged.
Create a virtual interface for each of the VLANs.
Connect the PC to the required ports with VLAN and assign them gateways to VLAN interfaces.
That is, I perform the standard procedure for setting up VLAN.
As I understand, further routing should work automatically. But unfortunately it does not work.
I addressed this problem with technical support. I changed the switch to an absolutely new one, but unfortunately the problem remained
All firewalls and antiviruses are disabled on hosts
Thank you!