Tagged VLANs not getting DHCP/traffic on 1920 and 5130 switches?

I have 3 clients all running Watchguard Fireboxes, Watchguard APs, and HP switches. 2 of the clients have 1920s, one has a 5130. The two 1920 clients have VLAN1 default corp lan and VLAN20 for guest wifi. The 5130 client has 6 VLANs...1corp/lan, 20guest, 30 production network, 40 redundant ISP from remote site 1, 50 voip, 60 remote site 1-fiber, 70 remote site 2-fiber.

The VLANs are created on the Watchguard Fireboxes except for clientwith 5130...it only has 1, 20, and 30 configured...40, 50, 60, 70 are not created on their Firebox yet.   Corp and Guest VLANS at all three clients have DHCP enabled on them in the Fireboxes.

Both 1920 switches have all ports untagged VLAN1. Port 24 of each switch goes to Firebox and is set for 1T/10U/PVID1/Trunk. Each switch port that has an AP plugged in to it is set as 1T/10U/PVID1/Trunk. If I log in to guest wireless I do not get an IP from the DHCP Server on VLAN20.  I have webGUI access to these switches via a remote machine at these sites, but have not tried configuring SSH/Telnet in webGUI to see if I can putty in to them from those remote machines.

The 5130 site has witch port 24 to Firebox set as Trunk/PVID1/Permit1,20,30,50,60,70 and everything else default...clients on VLAN1 can't get out to internet or ping router so I had to plug router in to another temporary port(default pvid1/access) to get them online and talking to the router. Switch port 23 to AP is Trunk/PVID1/Permit20 and everything else default...guest wireless clients not getting DHCP.  Switch fiber port 25 is remote site 1 and is Trunk/PVID1/Permit-1,20,50,60. Switch fiber port 26 is remote site 2 and is Trunk/PVID1/Permit-1,20,40,70.  Both those sites have internet connectivity.  The goal for those sites is separate VLANs from everything, but connectivity to the shared domain controller/fileserver on VLAN1.  The fact these two seem to work, yet their VLANs aren't yet configured in the Firebox, is odd and perhaps a hint at what might be wrong?  I have webGUI access via a remote machine at this site, enabled SSH and telnet to use putty from that remote machine, but ssh unexpectedly closes after login and telnet connects and immediately says failed login and I can't figure out why.

I do not have physical access to the sites with 1920 switches.  I have limited access to the site with the 5130 and major changes needed to be performed after hours and scheduled in advance.