Hi all,
In the past, I worked with HP 1810 24G switches and my system works properly.
Now I'm going to migrate HP 1820 24G switches, but I discover a little problem in my application, this is my scenario:
I have to connect two sites (site A and site B) throght 2 different phisical links, so, I place 1 switch x site and I configured
them as follow:
Site A and Site B has the same configurations:
port 1 to port 2 as part of trunk 1.
port 3 to port 12 as part of VLAN2 untagged
port 13 to port 26 as part of VLAN1 untagged
trunk1 as part of VLAN1 and VLAN2 Tagged
Trunk 1 = dynamic mode
spanning tree enable as RSTP
Now I connect two phisical links (radio links) between Port 1 site A to Port 1 site B nad between Port 2 site A and Port 2 site B.
The sistem seems to works properly but, if one of the radio link goes down, the connection between site A to site B goes down for about 90 seconds and then go UP.
I think that the problem is someting about the the algoritm used from the trunk to switch from one port to another, but I don't found a solution.
With the HP 1810 24 G the switching time was about 5 seconds!!!!.
Can anyone help me?
Tanks and exuseme for my english.