I want to set up a basic ACL or set of ACLs to
Permit source addresses in the range 10.0.28.1 to 10.0.31.254 to enter a port range.
Permit DHCP DISCOVER packets, that have the source address set to 0.0.0.0, to enter that same port range.
Deny all packets with other source addresses inbound access on that same port range.
Because most of the people looking after this network are very uncomfortable with CLIs, I really want to be able to do that in the Management Web GUI.
But I have so far been unable to do this in the GUI: In the CLI I seem to have gotten it to work with a single basic three-rule ACL and then that as a packet-filter on a port.
Help!
Permit source addresses in the range 10.0.28.1 to 10.0.31.254 to enter a port range.
Permit DHCP DISCOVER packets, that have the source address set to 0.0.0.0, to enter that same port range.
Deny all packets with other source addresses inbound access on that same port range.
Because most of the people looking after this network are very uncomfortable with CLIs, I really want to be able to do that in the Management Web GUI.
But I have so far been unable to do this in the GUI: In the CLI I seem to have gotten it to work with a single basic three-rule ACL and then that as a packet-filter on a port.
Help!