Good day, I ask you to help me figure out the organization of vlan in the office network. What do we have:
The Cisco RV320 Router on which to create the subnets:
- MGMT 10.100.5.0/24 VLAN 5 - DHCP OFF - ports Untagged / Inter VLAN Routing - enable
- LAN 10.100.10.0/24 VLAN 10 - DHCP ON (10.100.10.20 - 254) - Tagged / Inter VLAN Routing port - enable
- VoIP 10.100.20.0/24 VLAN 20 - DHCP ON (10.100.20.10 - 254) - Tagged / Inter VLAN Routing port - enable
- WiFi 10.100.30.0/24 VLAN 30 - DHCP ON (10.100.30.10 - 254) - Tagged / Inter VLAN Routing port - disable
With one cable, I connected port number 1 on the router to port number 48 on the switch
HPE 1820 48G Switch:
Edited the trunk (TRK1) as follows:
Trunk Name: Cisco
Admin mode: enabled
STP Mode: Disabled
Static Mode: Enabled
Load Balance: Source / Destination MAC. VLAN Ethertype incoming port
In members add the port that is connected to the router, the status has changed to Up
In VMware ESX Server (the server is connected to the switch on port 47 and 46):
Created a group of ports with VLAN20
Assigned a group to a virtual machine with a telephony server
I start the server and can not get the IP address from DHCP
I can't figure out how to configure vlan, could you help me? I know English very poorly and use a translator, sorry