Hi guys.
I have a doubt about the port security feature over the HP 1910 48G device.
I did the following commands in the CLI:
GLOBAL CONFIG:
port-security enable
port-security trap intrusion
INTERFACE CONFIG:
interface gig1/0/1
port-security max-mac-count 1
port-security port-mode autolearn
port-security intrusion-mode disableport
The feature works well when I plug another device in that port. The trap works well too. That happens exactly what I want to and my doubt is about the mac address table. The entry showing on the CLI is "NOAGED" and in the GUI the mac address entry does not appear anymore. When I try to add a static entry, the GUI says that this mac address already exists. I would like to know if it is a normal behaviour.
Software Version is 5.20 Release 1516.
The HP 1910 manual does not show any topic about.
Thanks in advance.